Will this bumper work with my vehicle's front sensors?

This bumper ships as a blank panel. If your OEM bumper has sensor cutouts, reference those hole locations on your factory cover and mark them on this piece before final installation. You'll need to drill matching openings to maintain sensor function.

Can I install this without removing the bumper reinforcement bar?

The Venice cover bolts to your vehicle's existing frame mounting points. You'll likely need to remove your factory bumper to access those fasteners cleanly, but the reinforcement bar itself stays in place. Check your vehicle's service manual for the exact mounting sequence.

What should I do to prepare this for paint?

Sand the entire surface with moderate grit to scuff the gelcoat, then clean away all dust. FRP is ready to accept epoxy primer and topcoat once prepped. Avoid leaving the raw material exposed to direct sunlight for extended periods before finishing.