Isolate Medical equipment on an Ethernet network to enhance patient safety Tripp Lite n234-mi-1005 Medical Ethernet Isolator protects staff, patients and medical Technology equipment in patient care vicinities from dangerous leakage currents that can travel through a copper-based Ethernet Network. It effectively isolates Medical equipment to protect patients, yet allows data to flow at Gigabit Ethernet speeds. Comply with IEC 60601-1 for use in the patient care vicinity the n234-mi-1005 complies with IEC 60601-1 and EMC/IEC 60601-1-2 safety standards for a network connection between a medical device and an Ethernet network or non-medical device (PC or laptop). because it meets IEC 60601-1 standards, This Medical network Isolator can be used in patient care vicinities. For example, you can use this 60601-1 network Isolator in the connection between a clinic’s network and the PC of a prolonged eeg system. (Note: you can only connect network components that comply with IEEE 802.3 or IEEE 802.3ab. You cannot connect telecommunication appliances, voltage supplies or similar devices.) install in-line on an Ethernet network This Ethernet Network Isolator has two RJ45 ports and acts as a coupler, joining two tested and approved Cat6 cables To complete the connection between compatible Medical equipment and a computer or data network. Because the cables are removable, you can replace a failed cable without replacing the Isolator. Completely plug and play, this RJ45 Isolator does not require software, drivers or a power supply. Comply with TAA requirements The n234-mi-1005 complies with the Federal Trade Agreements Act (TAA) for GSA Schedule purchases. ensuring reliability and performance.