Restore consistent heat output and low-odour performance with this replacement heater element. Designed for voltage-specific Incinolet units, it powers each burn cycle so waste incinerates completely and vents cleanly. For correct fit, confirm your serial number when ordering.   

Compatible with the following serial numbers:

240V, HEA007:

20000-29999

40000-49999

60000-69999

80000-89999

Key Features

240V voltage-matched replacement for reliable heating.

Supports complete incineration and reduced exterior odour when ventilation is set up correctly. 

Serial-number confirmation recommended for accurate variant selection. 

Service-friendly design; accessible with top and access panel removed. 

Note for 208V units: use the dedicated 208V heater, HEA009; do not substitute 120V or 240V elements. 

What’s Included

1 × Heater Element, 240V, HEA007

Installation & Care (Quick Tips)

Unplug the unit; remove ashpan, access panel, and top. 

Install the heater at the lowest position in the heater bracket; ensure proper seating. 

Verify the thermocouple tip touches the lower heater coil along the outside surface before reassembly. 

If troubleshooting a short, follow the manual’s orange-lead test procedure; replace the heater if indicated. 

For longevity, incinerate after each use and keep ash level low. 

Specs

Voltage options: 240V. 

SKUs: HEA007, 240V. 

FAQs

Where is the heater located?

Inside the chamber on a mounting bracket; access by removing the top and right-side access panel. 

Do 208V units use these heaters?

No; 208V models use a dedicated HEA009 heater.