INSTALLATION

Due to the curvature of the lens we recommend professional installation. However, there are many do it yourselfers that can perform this installation. Installing in a warmer environment makes the process a lot easier (~70 degrees or above). The installation can still be performed in colder environments (~45-70 degrees). You will most likely have to rely on a hair dryer or heat gun more. Our short video will illustrate the use of one. Always use the smallest amount of heat required.

We've tried a couple different installation methods. Starting with the inner corners and not wetting the material seems to work the best. Wet your fingers (soapy water) so you don't leave oils and smudge the adhesive on the back side. Using your fingers to squegee out the air will ensure that you do not scratch the material.

NOTE: There are two protective layers. One is on top of the overlay and one is on the bottom to protect the adhesive. Remove the overlay from the bottom to expose the adhesive and install. Once installed, in place, dried, and adhering to the final location, remove the top layer. This ensures your product will be protected against scratches while trying to install the item.